Command Line Reference Guide

Quality of Service (QoS) | 1143
Defaults
No default behavior or values
Command Modes
EXEC
Command
History
Example 1
(show cam
layer3-qos
linecard interface)
FTOS#sh cam layer3-qos interface gigabitethernet 2/1
Cam Port Dscp Proto Tcp Src Dst SrcIp DstIp DSCP Queue
Index Flag Port Port Marking
---------------------------------------------------------------------------------------------
23488 1 0 0 0x0 0 0 0.0.0.0/0 0.0.0.0/0 - TRUST-DSCP
FTOS#
In these figures outputs, note that:
• The entry TRUST-DSCP in the Queue column indicates that the trust diffserv is configured on the
policy-map.
• A hyphen (-) entry in the DSCP Marking column indicates that there is no DSCP marking.
• In the Proto column (Protocol), IP, ICMP, UDP, and TCP strings are displayed. For other
protocols, the corresponding protocol number is displayed.
Example 2
(show cam
layer3-qos
linecard port-set)
FTOS#show cam layer3-qos linecard 13 port-set 0
Cam Port Dscp Proto Tcp Src Dst SrcIp DstIp DSCP Queue
Index Flag Port Port Marking
---------------------------------------------------------------------------------------
24511 1 0 TCP 0x5 2 5 1.0.0.1/24 2.0.0.2/24 - TRUST-DSCP
24512 1 0 UDP 0x2 2 5 8.0.0.8/24 8.0.0.8/24 23 3
FTOS#
Example 3
(show cam
layer3-qos
linecard
interface)
FTOS#sh cam layer3-qos interface gigabitethernet 2/1
Cam Port Dscp Proto Tcp Src Dst SrcIp DstIp DSCP Queue
Index Flag Port Port Marking
-----------------------------------------------------------------------------------------
23488 1 56 0 0x0 0 0 0.0.0.0/0 0.0.0.0/0 - 7
23489 1 48 0 0x0 0 0 0.0.0.0/0 0.0.0.0/0 - 6
23490 1 40 0 0x0 0 0 0.0.0.0/0 0.0.0.0/0 - 5
23491 1 0 IP 0x0 0 0 10.1.1.1/32 20.1.1.1/32 - 0
23492 1 0 IP 0x0 0 0 10.1.1.1/32 20.1.1.2/32 - 0
interface interface Enter the keyword interface followed by one of the keywords below and slot/port or
number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the
slot/port information.
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by
the slot/port information.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
summary (OPTIONAL) Enter the keyword summary to display only the total number of CAM
entries.
Version 6.5.1.0 Introduced on E-Series