Command Line Reference Guide

Quality of Service (QoS) | 1133
qos-policy-input
c e s
Create a QoS input policy on the router.
Syntax
qos-policy-input qos-policy-name [layer2]
To remove an existing input QoS policy from the router, use no qos-policy-input qos-policy-name
[layer2] command.
Parameters
Defaults
Layer 3
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use this command to specify the name of the input QoS policy. Once input policy is specified,
rate-police can be defined. This command enables the qos-policy-input configuration mode—
(conf-qos-policy-in).
When changing a “service-queue” configuration in a QoS policy map, all QoS rules are deleted and
re-added automatically to ensure that the order of the rules is maintained. As a result, the Matched
Packets value shown in the “show qos statistics” command is reset.
Related
Commands
qos-policy-name
Enter your input QoS policy name in character format (32 character maximum).
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map.
Default: Layer 3
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 E-Series Only: Expanded to add support for Layer 2
Note: On ExaScale, FTOS cannot classify IGMP packets on a Layer 2 interface using Layer 3 policy map.
The packets always take the default queue, Queue 0, and cannot be rate-policed.
rate-police Incoming traffic policing function