Command Line Reference Guide

1132 | Quality of Service (QoS)
www.dell.com | support.dell.com
Usage
Information
Input policy map is used to classify incoming traffic to different flows using class-map, QoS policy, or
simply using incoming packets DSCP. This command enables policy-map-input configuration mode
(conf-policy-map-in).
Related
Commands
policy-map-output
c e s
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Usage
Information
Output policy map is used to assign traffic to different flows using QoS policy. This command enables
the policy-map-output configuration mode (conf-policy-map-out).
Related
Commands
Version 7.4.1.0 Expanded to add support for Layer 2
pre-Version 6.1.1.1 Introduced on E-Series
service-queue Assign a class map and QoS policy to different queues.
policy-aggregate Allow an aggregate method of configuring per-port QoS via policy maps.
service-policy input Apply an input policy map to the selected interface.
policy-map-name
Enter the name for the policy map in character format (16 characters maximum).
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on C-Series and S-Series
pre-Version 6.1.1.1 Introduced on E-Series
service-queue Assign a class map and QoS policy to different queues.
policy-aggregate Allow an aggregate method of configuring per-port QoS via policy maps.
service-policy output Apply an output policy map to the selected interface.