Command Line Reference Guide

1130 | Quality of Service (QoS)
www.dell.com | support.dell.com
match mac vlan
c e s
Configure a match criterion for a class map based on VLAN ID.
Syntax
match mac vlan number
Parameters
Defaults
None
Command Modes
CLASS-MAP
Command
History
Usage
Information
You must first enter the class-map command in order to access this command. You can match against
only one VLAN ID.
Related
Commands
policy-aggregate
c e s
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is
part of the policy map (input/output) applied on an interface.
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use no policy-aggregate qos-policy-name command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION (policy-map-input and policy-map-output)
Command
History
Usage
Information
C-Series and S-Series
Aggregate input/output QoS policy applies to all the port ingoing/outgoing traffic. Aggregate input/
output QoS policy can co-exist with per queue input/output QoS policies.
1. If only aggregate input QoS policy exists, input traffic conditioning configurations (rate-police)
will apply. Any marking configurations in aggregate input QoS policy will be ignored.
2. If aggregate input QoS policy and per class input QoS policy co-exist, then aggregate input QoS
policy will preempt per class input QoS policy on input traffic conditioning (rate-police). In other
words, if rate police configuration exists in aggregate QoS policy, the rate police configurations in
number
Enter the VLAN ID.
Range: 1–4094
Version 8.2.0.1 Introduced
class-map Create/access a class map.
qos-policy-name
Enter the name of the policy map in character format (32 characters maximum)
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series