Command Line Reference Guide

Quality of Service (QoS) | 1119
• All dot1p traffic is mapped to Queue 0 unless service-class dynamic dot1p is enabled on an
interface or globally.
• Layer 2 or Layer 3 service policies supercede dot1p service classes.
service-class bandwidth-weight
c s
Specify a minimum bandwidth for queues
Syntax
service-class bandwidth-weight queue0 number queue1 number queue2 number queue3 number
Parameters
Defaults
None
Command Modes
CONFIGURATION
Command
History
Usage
Information
Guarantee a minimum bandwidth to different queues globally using the command service-class
bandwidth-weight from CONFIGURATION mode. The command is applied in the same way as the
bandwidth-weight command in an output QoS policy. The bandwidth-weight command in
QOS-POLICY-OUT mode supercedes the service-class bandwidth-weight command.
show interfaces rate
e
Display information of either rate limiting or rate policing on the interface.
Syntax
show interfaces [interface] rate [limit | police]
Parameters
Command Mode
EXEC
EXEC Privilege
Command
History
Example 1
(rate limit)
FTOS#show interfaces gigabitEthernet 1/1 rate limit
Rate limit 300 (50) peak 800 (50)
Traffic Monitor 0: normal 300 (50) peak 800 (50)
Out of profile yellow 23386960 red 320605113
Traffic Monitor 1: normal NA peak NA
number
Enter the bandwidth-weight. The value must be a power of 2.
Range 1-1024.
Version 8.2.1.0 Introduced on C-Series and S-Series.
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For a SONET interface, enter the keyword
sonet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by
the slot/port information.
limit (OPTIONAL) Enter the keyword limit to view the outgoing traffic rate.
police (OPTIONAL) Enter the keyword police to view the incoming traffic rate.
pre-Version 6.1.1.1 Introduced on E-Series