Command Line Reference Guide

1060 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
(*, 225.1.2.1), uptime 00:00:01, expires 00:02:59, RP 165.87.70.1, flags: J
Incoming interface: Vlan 2, RPF neighbor 0.0.0.0
Outgoing interface list:
GigabitEthernet 4/11 RPF 165.87.32.2 00:00:01/00:02:59
GigabitEthernet 4/13 Upstream Port -/-
FTOS#show ip pim snooping tib vlan 2 225.1.2.1 165.87.1.7
PIM Multicast Snooping Table
Flags: J/P - (*,G) Join/Prune, j/p - (S,G) Join/Prune
SGR-P - (S,G,R) Prune
Timers: Uptime/Expires
* : Inherited port
(165.87.1.7, 225.1.2.1), uptime 00:00:08, expires 00:02:52, flags: j
Incoming interface: Vlan 2, RPF neighbor 0.0.0.0
Outgoing interface list:
GigabitEthernet 4/11 Upstream Port -/-
GigabitEthernet 4/13 DR Port -/-
GigabitEthernet 4/20 RPF 165.87.32.10 00:00:08/00:02:52
Table 43-117. show ip pim snooping tib Command Example Fields
Field Description
(S, G) Displays the entry in the PIM multicast snooping database.
uptime Displays the amount of time the entry has been in the PIM multicast route table.
expires Displays the amount of time until the entry expires and is removed from the database.
RP Displays the IP address of the RP/source for this entry.
flags List the flags to define the entries:
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
• F = FTOS is registering this entry for a multicast source
• T = packets were received via Shortest Tree Path
• J = first packet from the last hop router is received and the entry is ready to switch
to SPT
• K = acknowledge pending state
Incoming interface Displays the reverse path forwarding (RPF) interface towards the RP/source.
RPF neighbor Displays the next hop from this interface towards the RP/source.
Outgoing interface list: Lists the interfaces that meet one of the following criteria:
• a directly connect member of the Group.
• statically configured member of the Group.
• received a (*,G) Join message.