Command Line Reference Guide

PIM-Sparse Mode (PIM-SM) | 1051
ip pim rp-candidate
c e s
Configure a PIM router to send out a Candidate-RP-Advertisement message to the Bootstrap (BS)
router or define group prefixes that are defined with the RP address to PIM BSR.
Syntax
ip pim rp-candidate {interface [priority]
To return to the default value, enter no ip pim rp-candidate {interface [priority] command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
ip pim snooping
e
x
Enable PIM-SM snooping globally on a switch or on a VLAN interface.
Syntax
ip pim snooping [enable]
To disable PIM-SM snooping enter the no form of the command.
Defaults
Disabled.
Command Modes
CONFIGURATION: To configure PIM-SM snooping globally, enter the ip pim snooping enable
command in global configuration mode.
VLAN INTERFACE: To configure PIM-SM snooping on a VLAN interface, enter the
ip pim snooping
command in VLAN interface configuration mode.
interface
Enter the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/
port information.
• For a Loopback interface, enter the keyword
loopback followed by a number from 0 to
16383.
• For a Port Channel interface, enter the keyword port-channel followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by
the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
priority
(OPTIONAL) Enter the priority used in Bootstrap election process.
Range: zero (0) to 255
Default: 192
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on S-Series
pre-Version 6.1.1.1 Introduced on E-Series