Command Line Reference Guide

PIM-Sparse Mode (PIM-SM) | 1049
Command Modes
INTERFACE
Command
History
Example FTOS(conf)# ip access-list standard map1
FTOS(config-std-nacl)# permit 224.0.0.1/24
FTOS(config-std-nacl)#exit
FTOS(conf)#int gig 1/1
FTOS(config-if-gi-1/1)# ip pim ingress-interface-map map1
ip pim neighbor-filter
c e s
Configure this feature to prevent a router from participating in protocol independent Multicast (PIM).
Syntax
ip pim neighbor-filter {access-list}
To remove the restriction, use the no ip pim neighbor-filter {access-list} command.
Parameters
Defaults
Defaults.
Command Modes
CONFIGURATION.
Command
History
Usage
Information
Do not enter this command before creating the access-list.
ip pim query-interval
c e s
Change the frequency of PIM Router-Query messages.
Syntax
ip pim query-interval seconds
To return to the default value, enter no ip pim query-interval seconds command.
Parameters
Defaults
30 seconds
Command Modes
INTERFACE
Command
History
Version 8.4.1.0 Introduced
access-list
Enter the name of a standard access list. Maximum 16 characters.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.6.1.0 Introduced on the E-Series
seconds
Enter a number as the number of seconds between router query messages.
Default: 30 seconds
Range: 0 to 65535
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series on port-channels and S-Series