Command Line Reference Guide

PIM-Dense Mode (PIM-DM) | 1041
42
PIM-Dense Mode (PIM-DM)
Overview
PIM-DM is supported on E-Series ExaScale e
x
in FTOS 8.1.1.0. and later.
PIM-DM is supported on E-Series TeraScale
e
t
, C-Series c, and S-Series s platforms in FTOS
8.4.2.0. and later.
For information on the commands required to configure and use PIM-Dense Mode (PIM-DM), refer to:
• IPv4 PIM Commands
• IPv4 PIM-Dense Mode Commands
IPv4 PIM-Dense Mode Commands
The IPv4 PIM-Dense Mode (PIM-DM) commands are:
• ip pim dense-mode
ip pim dense-mode
c e s
Enable PIM Dense-Mode (PIM-DM) Multicast capability for the specified interface.
Syntax
ip pim dense-mode
To disable PIM-DM, use the no ip pim dense-mode command.
Defaults
Disabled
Command Modes
INTERFACE
Command
History
Example FTOS#conf
FTOS(conf)# interface gigabitethernet 3/27
FTOS(gigabitethernet 3/27)# ip address 10.1.1.1 /24
FTOS(gigabitethernet 3/27)# no shut
FTOS(gigabitethernet 3/27)# ip pim dense-mode
FTOS#
Version 8.4.2.1 Introduced on the C-Series and S-Series
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 8.1.1.0 Introduced on the E-Series ExaScale
Version 6.5.1.0 Introduced