Command Line Reference Guide

1034 | Policy-based Routing (PBR)
www.dell.com | support.dell.com
ip redirect-group
c e s
Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an
interface by entering this command multiple times.
Syntax
ip redirect-group redirect-list-name
To remove a redirect list from an interface, use the no ip redirect-group name command.
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE (conf-if-vl-)
Command
History
Usage
Information
Any number of redirect-groups can be applied to an interface. A redirect list can contain any number of
configured rules. These rules includes the next-hop IP address where the incoming traffic is to be
redirected.
If the next hop address is reachable, traffic is forwarded to the specified next hop. Otherwise the
normal routing table is used to forward traffic. When a redirect-group is applied to an interface and the
next-hop is reachable, the rules are added into the PBR CAM region. When incoming traffic hits an
entry in the CAM, the traffic is redirected to the corresponding next-hop IP address specified in the
rule.
Related
Commands
ip redirect-list
c e s
Configure a redirect list and enter the REDIRECT-LIST mode.
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, enter no ip redirect-list.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
redirect-list-name Enter the name of a configured redirect list.
Version 8.4.2.1 Introduced on the C-Series and S-Series
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 7.4.2.0 Added support for LAG and VLAN interfaces
Version 6.5.3.0 Introduced on the E-Series ExaScale
Note: Apply redirect list to physical, VLAN, or LAG interfaces only.
show cam pbr Display the content of the PBR CAM.
show ip redirect-list Display the redirect-list configuration.
redirect-list-name Enter the name of a redirect list.
Version 8.4.2.1 Introduced on the C-Series and S-Series
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 6.5.3.0 Introduced on the E-Series ExaScale