Command Line Reference Guide

1030 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
Group Mem LSA Count 0
Type-7 LSA count 0
Intra Area Pfx LSA Count 2
Intra Area TE LSA Count 2
E1200-T2C2#sh ipv6 ospf neighbor
Neighbor ID Pri State Dead Time Interface ID Interface
63.114.8.36 1 FULL/DR 00:00:37 4 Gi 9/0
FTOS#
show ipv6 ospf interface
c e
View OSPFv3 interface information.
Syntax
show ipv6 ospf [interface]
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
Command
History
Example FTOS#show ipv6 ospf interface gigabitethernet 1/0
GigabitEthernet 1/0 is up, line protocol is up
Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID 67420217
Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
NetworkType BROADCAST, Cost: 1, Passive: No
Transmit Delay is 100 sec, State DR, Priority 1
Designated router on this network is 11.1.1.1 (local)
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 1, Retransmit 5
FTOS#
interface
(OPTIONAL) Enter one of the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/
port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
C-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by
the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094
Version 7.8.1.0 Added support for C-Series
Version 7.4.1.0 Introduced