Command Line Reference Guide

102 | Control and Monitoring
www.dell.com | support.dell.com
send
c e s
Send messages to one or all terminal line users.
Syntax
send [*] | [line ] | [aux] | [console] | [vty]
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
Command
History
Usage
Information
Messages can contain an unlimited number of lines, however each line is limited to 255 characters. To
move to the next line, use the <CR>. To send the message use CTR-Z, to abort a message use CTR-C.
service timestamps
c e s
Add time stamps to debug and log messages. This command adds either the uptime or the current time
and date.
Syntax
service timestamps [debug | log] [datetime [localtime] [msec] [show-timezone] | uptime]
Parameters
Defaults
Not configured.
*
Enter the asterisk character * to send a message to all tty lines.
line
Send a message to a specific line.
Range: 0 to 11
aux Enter the keyword aux to send a message to an Auxiliary line.
Note: This option is supported on E-Series only.
console Enter the keyword console to send a message to the Primary terminal line.
vty Enter the keyword vty to send a message to the Virtual terminal
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.5.1.0 Introduced on E-Series
debug (OPTIONAL) Enter the keyword debug to add timestamps to debug messages.
log (OPTIONAL) Enter the keyword log to add timestamps to log messages with severity 0
to 6.
datetime (OPTIONAL) Enter the keyword datetime to have the current time and date added to the
message.
localtime (OPTIONAL) Enter the keyword localtime to include the localtime in the timestamp.
msec (OPTIONAL) Enter the keyword msec to include milliseconds in the timestamp.
show-timezone (OPTIONAL) Enter the keyword show-timezone to include the time zone information
in the timestamp.
uptime (OPTIONAL) Enter the keyword uptime to have the timestamp based on time elapsed
since system reboot.