Reference Guide

970 | Stacking S-Series Switches
www.dell.com | support.dell.com
Create a Virtual Stack Unit on an S-Series Stack
Use virtual stack units to configure ports on the stack before adding a new unit, or to prevent FTOS from
assigning a particular stack-number.
Display Information about an S-Series Stack
Displaying Information about an S-Series Stack—show system
FTOS#show system
Stack MAC : 00:01:e8:d5:f9:6f
-- Unit 0 --
Unit Type : Member Unit
Status : online
Next Boot : online
Required Type : S50V - 48-port E/FE/GE with POE (SB)
Current Type : S50V - 48-port E/FE/GE with POE (SB)
Master priority : 0
Hardware Rev : 2.0
Num Ports : 52
Up Time : 30 min, 7 sec
FTOS Version : 7.8.1.0
Jumbo Capable : yes
POE Capable : yes
Burned In MAC : 00:01:e8:d5:ef:81
No Of MACs : 3
Task Command Syntax Command Mode
Create a virtual stack unit. stack-unit provision CONFIGURATION
Task Command Syntax Command Mode
Display for stack-identity, status, and hardware information on every
unit in a stack (refer to Displaying Information about an S-Series
Stack—show system).
show system EXEC Privilege
Display most of the information in show system, but in a more
convenient tabular form (refer to Displaying Information about an
S-Series Stack—show system brief).
show system brief EXEC Privilege
Display the same information in show system, but only for the
specified unit (refer to Displaying Information about an S-Series
Stack—show system brief).
show system stack-unit EXEC Privilege
Display topology and stack link status for the entire stack. The
available options separate the show system stack-port output into
topology information from link status information (refer to
Displaying Information about an S-Series Stack—show system
brief).
show system stack-ports
[status | topology]
EXEC Privilege