Reference Guide

960 | Stacking S-Series Switches
www.dell.com | support.dell.com
Stack#3w1d15h: %STKUNIT1-M:CP %POLLMGR-2-ALT_STACK_UNIT_STATE: Alternate Stack-unit is
not present
3w1d15h: %STKUNIT1-M:CP %CHMGR-5-STACKUNITDETECTED: Stack unit 2 present
Going for reboot. Reason is Stack merge
3w1d15h: %STKUNIT1-M:CP %CHMGR-2-STACK_UNIT_DOWN: Stack-unit 0 down - card removed
[bootup messages omitted]
Stack#show system brief
Stack MAC : 00:01:e8:d5:ef:81
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
---------------------------------------------------------------------------
0 Member online S50V S50V 7.8.1.0 52
1 Standby online S50N S50N 7.8.1.0 52
2 Management online S50V S50V 7.8.1.0 52
3 Member not present
4 Member not present
5 Member not present
6 Member not present
7 Member not present
Management Access on S-Series Stacks
You can access the stack via the console port or VTY line.
• Console access: You may access the stack through the console port of the stack manager only. Like a
standby RPM, the console port of the standby unit does not provide management capability; only a
limited number of commands are available. Member units provide a severely limited set of commands,
as shown in the following example.
• Remote access: You may access the stack with SNMP, SSH, or Telnet through any enabled, Layer 3
interface on any stack unit. There is no dedicated management port or management route table.
------------------------CONSOLE ACCESS ON THE STANDBY----------------------------------
Stack(standby)>?
disable Turn off privileged commands
enable Turn on privileged commands
exit Exit from the EXEC
show Show running system information
ssh-peer-stack-unit Open a SSH connection to the peer Stack-unit
telnet-peer-stack-unit Open a telnet connection to the peer Stack-unit
terminal Set terminal line parameters
Stack(standby)>show ?
calendar Display the hardware calendar
clock Display the system clock
command-history CLI command history
redundancy Current Stack unit HA status
version Software version
------------------------CONSOLE ACCESS ON A MEMBER-------------------------------------
Stack(stack-member-0)#?
reset-self Reset this unit alone
show Show running system information