Reference Guide

914 | sFlow
www.dell.com | support.dell.com
sFlow Show Commands
FTOS includes the following sFlow display commands:
• Show sFlow Globally on page 49
• Show sFlow on an Interface on page 50
• Show sFlow on a Line Card on page 50
Show sFlow Globally
Use the following command to view sFlow statistics:
The following example is a sample output from the
show sflow command:
FTOS#show sflow
sFlow services are enabled
Global default sampling rate: 32768
Global default counter polling interval: 20
1 collectors configured
Collector IP addr: 133.33.33.53, Agent IP addr: 133.33.33.116, UDP port: 6343
77 UDP packets exported
0 UDP packets dropped
165 sFlow samples collected
69 sFlow samples dropped due to sub-sampling
Linecard 1 Port set 0 H/W sampling rate 8192
Gi 1/16: configured rate 8192, actual rate 8192, sub-sampling rate 1
Gi 1/17: configured rate 16384, actual rate 16384, sub-sampling rate 2
Show sFlow on an Interface
Use the following command to view sFlow information on a specific interface:
The following example is a sample output from the
show sflow interface command.
FTOS#show sflow interface gigabitethernet 1/16
Gi 1/16
Configured sampling rate :8192
Actual sampling rate :8192
Sub-sampling rate :2
Counter polling interval :15
Samples rcvd from h/w :33
Samples dropped for sub-sampling :6
Command Syntax Command Mode Purpose
show sflow EXEC Display sFlow configuration information and statistics.
Command Syntax Command Mode Purpose
show sflow interface
interface-name
EXEC Display sFlow configuration information and statistics on a specific interface.