Reference Guide

830 | Routing Information Protocol
www.dell.com | support.dell.com
RIP Configuration Example
The example in this section shows the command sequence to configure RIPv2 on the two routers shown in
Figure 45-1 — “Core 2” and “Core 3”. The host prompts used in the example screenshots reflect those
names. The screenshots are divided into the following groups of command sequences:
• Configuring RIPv2 on Core 2
• Core 2 Output
• RIP Configuration on Core 3
• Core 3 RIP Output
• RIP Configuration Summary
Figure 45-1. RIP Topology Example
Configuring RIPv2 on Core 2
Core2(conf-if-gi-2/31)#
Core2(conf-if-gi-2/31)#router rip
Core2(conf-router_rip)#ver 2
Core2(conf-router_rip)#network 10.200.10.0
Core2(conf-router_rip)#network 10.300.10.0
Core2(conf-router_rip)#network 10.11.10.0
Core2(conf-router_rip)#network 10.11.20.0
Core2(conf-router_rip)#show config
!
router rip
network 10.0.0.0
version 2
Core2(conf-router_rip)#
Core 2 Output
The screenshots in this section are:
• Example of RIP Configuration Response from Core 2: Using
show ip rip database command to
display Core 2 RIP database
• Using show ip route Command to Show RIP Configuration on Core 2: Using
show ip route command
to display Core 2 RIP setup
GigE 3/11
GigE 3/11
10.11.30.1 /24
GigE 3/21
GigE 3/21
10.11.20.1 /24
GigE 2/11
GigE 2/11
10.11.10.1 /24
GigE 2/31
GigE 2/31
10.11.20.2 /24
Core 2 Core 3
GigE
2/31
GigE
3/21
GigE 3/43
GigE 3/43
192.168.1.0 /24
GigE 3/44
GigE 3/44
192.168.2.0 /24
GigE 2/41
GigE 2/41
10.200.10.0 /24
GigE 2/42
GigE 2/42
10.300.10.0 /24