Reference Guide

826 | Routing Information Protocol
www.dell.com | support.dell.com
To view the current RIP configuration, use the show running-config command in the EXEC mode or the
show config command in the ROUTER RIP mode.
Set send and receive version
To specify the RIP version, use the version command in the ROUTER RIP mode. To set an interface to
receive only one or the other version, use the
ip rip send version or the ip rip receive version commands
in the INTERFACE mode.
To change the RIP version globally in FTOS, use the following command in the ROUTER RIP mode:
You can set one RIP version globally on the
system. This command sets the RIP version for RIP traffic on
the interfaces participating in RIP unless the interface was specifically configured for a specific RIP
version.
Use the
show config command in the ROUTER RIP mode to see whether the version command is
configured. You can also use the
show ip protocols command in the EXEC mode to view the routing
protocols configuration.
The following output text shows an example of the RIP configuration after the ROUTER RIP mode
version command is set to RIPv2. When the ROUTER RIP mode version command is set, the interface
(GigabitEthernet 0/0) participating in the RIP process is also set to send and receive RIPv2.
FTOS#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 23
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface Recv Send
GigabitEthernet 0/0 2 2
Routing for Networks:
10.0.0.0
redistribute ospf process-id [match external
{1 | 2} | match internal] [metric value]
[route-map map-name]
ROUTER RIP Include specific OSPF routes in RIP. Configure
the following parameters:
• process-id range: 1 to 65535
• metric range: 0 to 16
• map-name: name of a configured route
map.
Command Syntax Command Mode Purpose
version {1 | 2} ROUTER RIP Set the RIP version sent and received on the system.
Command Syntax Command Mode Purpose