Reference Guide

ManualsBrandsDell ManualsserversDell Force10 E600i

771

772

773

774

775

776

777

778

779

780

Port Monitoring | 777

To delete one or more destination ports from a destination session, enter the no source remote-vlan vlan-id

destination command.

To change the RPM VLAN used in the destination session, you must first remove all destination ports.

Then delete the current VLAN by entering the

no monitor session session-id source remote-vlan vlan-id

command and re-enter the monitor session session-id source remote-vlan command to configure the new

VLAN ID.

To reconfigure destination ports as untagged ports, enter the

untagged destination command.

2 source remote-vlan vlan-id

destination {single-interface

| range {interface-list |

interface-range |

mixed-interface-list}}

MONITOR

SESSION

Associate the RPM VLAN used to transport mirrored

traffic with this destination session and configure the

destination ports to which an analyzer is a connected.

single-interface is one of the following values:

gigabitethernet slot/port

tengigabitethernet slot/port

range interface-list specifies multiple interfaces

separated by a comma and space: single-interface,

single-interface, single-interface...

range interface-range specifies one of the following

interface ranges:

gigabitethernet slot/first_port-last_port

tengigabitethernet slot/first_port-last_port

A space is required before and after the dash (-).

range mixed-interface-list specifies single interfaces

and interface ranges in any order: single-interface,

interface-range, single-interface...

tagged destination

{

single-interface | range

interface-range}

MONITOR

SESSION

(Optional) Configure destination ports so that the

reserved VLAN tag is added to the monitored traffic

sent to an analyzer.

Default: Destination ports send untagged packets so

that the reserved VLAN ID is removed and the

original monitored packet is analyzed.