Reference Guide

776 | Port Monitoring
www.dell.com | support.dell.com
To delete one or more source ports from a mirroring session, enter the no source interfaces destination
remote-vlan vlan-id direction direction command, specifying the ports to be deleted, remote VLAN ID, and
traffic direction in the command syntax.
To change the RPM VLAN used in a source session, you can delete the session (
no monitor session
command) or remove the current configuration by entering the no source interfaces destination
remote-vlan vlan-id direction direction command. Then re-enter the complete source command as
described above to configure a new reserved VLAN for the same source ports in the session.
To delete one or more source VLANs from a mirroring session, enter the
no source interfaces {vlan vlan-id
| vlan range vlan-ids} destination remote-vlan vlan-id direction direction command, specifying the source
VLANs to be deleted, the source ports, remote VLAN ID, and traffic direction in the command syntax.
To update the source VLANs in a mirroring session, you must first remove the RPM configuration by
entering the complete
no source interfaces {vlan vlan-id | vlan range vlan-ids} destination remote-vlan
vlan-id direction direction command. Then re-enter the command, specifying the source VLANs, the source
ports, remote VLAN ID, and traffic direction in the command syntax.
4 flow-based enable MONITOR
SESSION
(Optional) Enable flow-based mirroring for this source session to
monitor only specified traffic.
Refer to Flow-based Monitoring for more information.
5 Repeat Steps 1 to 4 on other source switches to configure additional source ports for this session.
Configure a Destination Session on Multiple Switches
Step Command Syntax Command Mode Task
1 monitor session session-id CONFIGURATION Configure the destination session for remote port mirroring
and enter Monitor Session configuration mode.
Configure a Source Session on Multiple Switches
Ste
p Command Syntax Command Mode Task