Reference Guide

702 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
Use the following commands in EXEC Privilege mode to get general route and links status information.
Use the following command in EXEC Privilege mode to view the OSPF configuration for a neighboring
router:
Use the following command in EXEC Privilege mode to configure the debugging options of an OSPFv3
process:
Command Syntax Command Mode Usage
show ipv6 route summary
EXEC Privilege View the summary information of the IPv6 routes
show ipv6 ospf database EXEC Privilege View the summary information for the OSPFv3 database
Command Syntax Command Mode Usage
show ipv6 ospf neighbor
EXEC Privilege View the configuration of OSPFv3 neighbors.
Command Syntax Command Mode Usage
debug ipv6 ospf packet
{type slot/port}
EXEC Privilege View debug messages for all OSPFv3 interfaces.
• packet: view OSPF packet information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information (e.g.
passive-interface gi 2/1).
• For a port channel, enter the keyword port-channel followed by
a number from 1 to 255 for TeraScale and ExaScale(e.g.
passive-interface po 100)
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information (
e.g. passive-interface ten 2/3).
• For a VLAN, enter the keyword vlan followed by a number from
1 to 4094 (e.g. passive-interface vlan 2222).
E-Series ExaScale platforms support 4094 VLANs with FTOS
version 8.2.1.0 and later. Earlier ExaScale supports 2094
VLANS.