Reference Guide

576 | Link Layer Discovery Protocol
www.dell.com | support.dell.com
Viewing the LLDP Configuration
Display the LLDP configuration using the command show config in either CONFIGURATION or
INTERFACE mode, as shown in the first and second examples, respectively
Viewing LLDP Global Configurations
R1(conf)#protocol lldp
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
hello 10
no disable
R1(conf-lldp)#
Viewing LLDP Interface Configurations
R1(conf-lldp)#exit
R1(conf)#interface gigabitethernet 1/31
R1(conf-if-gi-1/31)#show config
!
interface GigabitEthernet 1/31
no ip address
switchport
no shutdown
R1(conf-if-gi-1/31)#protocol lldp
R1(conf-if-gi-1/31-lldp)#show config
!
protocol lldp
R1(conf-if-gi-1/31-lldp)#
Viewing Information Advertised by Adjacent LLDP Agents
Display brief information about adjacent devices using the command show lldp neighbors, as shown in the
first example. Display all of the information that neighbors are advertising using the command
show lldp
neighbors detail, as shown in the second example.
Viewing Brief Information Advertised by Adjacent LLDP Agents
R1(conf-if-gi-1/31-lldp)#end
R1(conf-if-gi-1/31)#do show lldp neighbors
Loc PortID Rem Host Name Rem Port Id Rem Chassis Id
-------------------------------------------------------------------------
Gi 1/21 - GigabitEthernet 2/11 00:01:e8:06:95:3e
Gi 1/31 - GigabitEthernet 3/11 00:01:e8:09:c2:4a