Reference Guide

52 | Getting Started
www.dell.com | support.dell.com
core1#$//copy ftp://myusername:mypassword@10.10.10.10//FTOS/FTOS-EF-8.2.1.0.bin
flash://
Destination file name [FTOS-EF-8.2.1.0.bin.bin]:
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
26292881 bytes successfully copied
Save the Running-configuration
The running-configuration contains the current system configuration. Dell Force10 recommends that you
copy your running-configuration to the startup-configuration. The system uses the startup-configuration
during boot-up to configure the system. The startup-configuration is stored in the internal flash on the
primary RPM by default, but it can be saved onto an external flash (on an RPM) or a remote server.
To save the running-configuration:
Note: The commands in this section follow the same format as those in Copy Files to and from the
System but use the filenames startup-configuration and running-configuration. These commands assume
that current directory is the internal flash, which is the system default.
Task Command Syntax Command Mode
Save the running-configuration to:
EXEC Privilege
the startup-configuration on the
internal flash of the primary RPM
copy running-config startup-config
the internal flash on an RPM copy running-config rpm{0|1}flash://filename
Note: The internal flash memories on the RPMs are synchronized whenever there
is a change, but only if the RPMs are running the same version of FTOS.
Note: FTOS supports IPv4 and IPv6 addressing for FTP, TFTP, and SCP (in the
hostip field).
the external flash of an RPM copy running-config rpm{0|1}slot0://filename
an FTP server copy running-config ftp://
username:password@{hostip | hostname}/
filepath/filename
a TFTP server copy running-config tftp://{hostip | hostname}/
filepath/filename
an SCP server copy running-config scp://{hostip | hostname}/
filepath/filename
Note: When copying to a server, a hostname can only be used if a DNS server is configured.