Reference Guide

464 | IPv4 Addressing
www.dell.com | support.dell.com
These entries do not age and can only be removed manually. To remove a static ARP entry, use the no arp
ip-address command syntax.
To view the static entries in the ARP cache, use the
show arp static command in the EXEC privilege
mode.
FTOS#show arp
Protocol Address Age(min) Hardware Address Interface VLAN CPU
--------------------------------------------------------------------------------
Internet 10.1.2.4 17 08:00:20:b7:bd:32 Ma 1/0 - CP
FTOS#
Enable Proxy ARP
By default, Proxy ARP is enabled. To disable Proxy ARP, use no proxy-arp command in the interface
mode.
To re-enable Proxy ARP, use the following command in the INTERFACE mode:
To view if Proxy ARP is enabled on the interface, use the
show config command in the INTERFACE
mode. If it is not listed in the show config command output, it is enabled. Only nondefault information is
displayed in the
show config command output.
Command Syntax Command Mode Purpose
ip proxy-arp
INTERFACE Re-enable Proxy ARP.