Reference Guide

338 | Force10 Resilient Ring Protocol
www.dell.com | support.dell.com
Set FRRP Timers
Clear FRRP counters
Use one of the following commands to clear the FRRP counters.
Show FRRP configuration
Use the following command to view the configuration for the FRRP group.
Show FRRP information
Use one of the following commands show general FRRP information.
5 member-vlan vlan-id
{range}
CONFIG-FRRP Identify the Member VLANs for this FRRP group
VLAN-ID, Range: VLAN IDs for the ring’s Member
VLANs.
6
no disable
CONFIG-FRRP Enable this FRRP group on this switch.
Step Command Syntax Command Mode Purpose
1 timer
{hello-interval|dead-interval}
milliseconds
CONFIG-FRRP Enter the desired intervals for Hello-Interval or
Dead-Interval times.
Hello-Interval: 50-2000, in increments of 50 (default is 500)
Dead-Interval: 50-6000, in increments of 50 (default is 1500)
The Dead-Interval time should be set at 3x the Hello-Interval.
Command Syntax Command Mode Purpose
clear frrp ring-id EXEC PRIVELEGED Clear the counters associated with this Ring ID
Ring ID: 1-255
clear frrp EXEC PRIVELEGED Clear the counters associated with all FRRP groups
Command Syntax Command Mode Purpose
show configuration CONFIG-FRRP Show the configuration for this FRRP group
Command Syntax Command Mode Purpose
show frrp ring-id EXEC or EXEC PRIVELEGED Show the information for the identified FRRP group.
Ring ID: 1-255
Step Command Syntax Command Mode Purpose