Reference Guide

280 | Content Addressable Memory
www.dell.com | support.dell.com
L2Acl : 14
Pvst : 50
Qos : 12
L2pt : 13
Frrp : 5
[output omitted]
FTOS(conf)#do copy run start
File with same name already exist.
Proceed to copy the file [confirm yes/no]: yes
!
8676 bytes successfully copied
02:00:49: %RPM0-P:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in
flash by default
FTOS(conf)#do show cam-l2acl | find “Line card 1”
-- Line card 1 --
Current Settings(in percent) Next Boot(in percent)
Sysflow : 6 100
L2Acl : 14 5
Pvst : 50 5
Qos : 12 5
L2pt : 13 5
Frrp : 5 5
Return to the Default CAM Configuration
Return to the default CAM Profile, microcode, IPv4Flow, or Layer 2 ACL configuration using the
keyword
default from EXEC Privilege mode or from CONFIGURATION mode, as shown in the following
example.
FTOS(conf)#cam-profile ?
default Enable default CAM profile
eg-default Enable eg-default CAM profile
ipv4-320k Enable 320K CAM profile
ipv4-egacl-16k Enable CAM profile with 16K IPv4 egress ACL
ipv6-extacl Enable CAM profile with extended ACL
l2-ipv4-inacl Enable CAM profile with 32K L2 and 28K IPv4 ingress ACL
unified-default Enable default unified CAM profile
FTOS(conf)#cam-profile default microcode ?
default Enable default microcode
lag-hash-align Enable microcode with LAG hash align
lag-hash-mpls Enable microcode with LAG hash MPLS
FTOS(conf)#cam-profile default microcode default
FTOS(conf)#cam-ipv4flow ?
default Reset IPv4flow CAM entries to default setting
multicast-fib Set multicast FIB entries
FTOS(conf)#cam-l2acl ?
default Reset L2-ACL CAM entries to default setting
system-flow Set system flow entries