Reference Guide

Content Addressable Memory | 275
The command show running-config cam-profile shows the current profile and microcode.
FTOS#show running-config cam-profile
!
cam-profile default microcode default
FTOS#
View CAM-ACL settings
View the current cam-acl settings for the C-Series and S-Series systems chassis and each component using
the command
show cam-acl, as shown in the following example.
FTOS# show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
Ipv4Qos : 2
L2Qos : 2
L2PT : 1
IpMacAcl : 2
VmanQos : 0
VmanDualQos : 0
-- Line card 0 --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
Ipv4Qos : 2
L2Qos : 2
L2PT : 1
IpMacAcl : 2
VmanQos : 0
VmanDualQos : 0
-- Line card 6 --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
Ipv4Qos : 2
L2Qos : 2
L2PT : 1
IpMacAcl : 2
VmanQos : 0
VmanDualQos : 0
Note: If you select the CAM profile from CONFIGURATION mode, the output of this command does not
reflect any changes until you save the running-configuration and reload the chassis.