Reference Guide

Bidirectional Forwarding Detection | 185
To change parameters for all VRRP sessions:
To change parameters for a particular VRRP session:
View session parameters using the command
show bfd neighbors detail, as shown in the example in
Changing physical port session parameters.
Disabling BFD for VRRP
If any or all VRRP sessions are disabled, the sessions are torn down. A final Admin Down control packet
is sent to all neighbors and sessions on the remote system change to the Down state (Message 3).
To disable all VRRP sessions on an interface:
To disable all VRRP sessions in a particular VRRP group:
To disable a particular VRRP session:
Step Task Command Syntax Command Mode
1 Change parameters for all VRRP
sessions.
vrrp bfd all-neighbors interval milliseconds
min_rx milliseconds multiplier value role
[active | passive]
INTERFACE
Step Task Command Syntax Command Mode
1 Change parameters for a particular
VRRP session.
vrrp bfd neighbor ip-address interval
milliseconds min_rx milliseconds multiplier
value role [active | passive]
INTERFACE
Step Task Command Syntax Command Mode
1 Disable all VRRP sessions on an
interface.
no vrrp bfd all-neighbors INTERFACE
Step Task Command Syntax Command Mode
1 Disable all VRRP sessions in a
VRRP group.
bfd disable VRRP
Step Task Command Syntax Command Mode
1 Disable a particular VRRP session on
an interface.
no vrrp bfd neighbor ip-address INTERFACE