Reference Guide

614 | Interfaces
www.dell.com | support.dell.com
Use the following information to enter specific values to set the autonegotiation speed and duplex
settings for switch ports. Entering specific values allows users to limit the speed available on ports to
the values that are specified.
Related
Commands
speed (Management interface)
c e
Set the speed for the Management interface.
Syntax
speed {10 | 100 | auto}
To return to the default setting, use the no speed {10 | 100} command.
Parameters
Defaults
auto
Note: The command speed auto 100 in FTOS is an exact equivalent of speed auto 100 in
IOS
Table 24-11. Speed Settings and Auto-Negotiation Settings
10/100/1000 Ethernet Ports
speed {10 | 100 | 1000 | auto}
Users can configure the following combinations:
speed 10
speed 100
speed 1000
speed auto
speed auto 10
speed auto 100
speed auto 1000
speed auto 10 100
speed auto 10 1000
speed auto 100 1000
speed auto 10 100 1000
duplex (10/100
Interfaces)
Configure duplex mode on physical interfaces with the speed set to 10/100.
negotiation auto Enable or disable auto-negotiation on an interface.
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 100 Mb/s.
auto Enter the keyword auto to set the interface to auto-negotiate its speed.