Command Line Reference Guide

626 | Interfaces
www.dell.com | support.dell.com
• In the event of fragmented packets, egress port of the first fragment.
• In the event of fragmented packets, egress port of the subsequent fragments.
Example
show port-channel-flow outgoing-port-channel number incoming-interface interface
source-mac address destination-mac address
• Load-balance is configured for MAC
• Load balance is configured for IP 4-tuple/2-tuple for the C-Series and S-Series
• A non-IP payload is going out of Layer 2 LAG interface that is a member of VLAN with an IP
address.
Figure 24-47. show port-channel-flow Command for MAC Addresses
Example
On the E-Series only:
show port-channel-flow outgoing-port-channel number incoming-interface interface
source-ip address destination-ip address {protocol number [icmp/tcp/udp]}
{source-port number destination-port number}
• Load balance is configured for IP 5-tuple/3-tuple.
• An IP payload is going out of a Layer 2 LAG interface that is a member of a VLAN with an IP
address.
Force10#show port-channel-flow outgoing-port-channel 2 incoming-interface gi
3/0 source-ip 2.2.2.0 destination-ip 3.2.3.1 protocol tcp source-port 5
destination-port 6
Egress Port for port-channel 2, for the given flow:
Unfragmented packet: Gi 1/6
Fragmented packets (first fragment): Gi 1/12
Fragmented packets (remaining fragments): Gi 1/12
Related
Commands
Time Domain Reflectometer (TDR)
TDR is supported on E-Series ExaScale e
x
with FTOS 8.2.1.0. and later.
TDR is useful for troubleshooting an interface that is not establishing a link; either it is flapping or not
coming up at all. TDR detects open or short conditions of copper cables on 100/1000 Base-T modules.
• tdr-cable-test
• show tdr
Force10#show port-channel-flow outgoing-port-channel 1 incoming-interface gi 3/0
source-mac 00:00:50:00:00:00 destination-mac 00:00:a0:00:00:00
Egress Port for port-channel 1, for the given flow, is Te 13/01
load-balance (E-Series) Balance traffic over E-Series port channel members.