Users Guide

62 | Removing and Replacing Components

www.dell.com | support.dell.com

Remove a DC Power Supply

Step Task

1 Ensure that the remote power source is in the OFF position and that the PEM status light is off.

• PEM 0 connects to remote power source 0.

• PEM 1 connects to remote power source 1.

2 Loosen the retaining screw and remove the PEM safety cover.

3 Switch the Over Current Protector (located on the PEM front panel) to the OFF position.

4 Loosen the Locking screws.

5 Lift and hold the PEM interlock lever to release the PEM

6 While holding the interlock lever up, using the bottom handle, pull the PEM straight out of the slot.

F



Safety

cover

etaining

screw

CC-E1200-PWR-DC

Label, Front Bezel, PEM E1200 with Bus bar

550-00061-01 Rev A

-48/-60Vdc

150A, 7200VA

Status

Latch Release

PEM interlock

lever

Over-current protecto

Lockin

screws

Studs

FN00102lp