Command Line Reference Guide

868 | Link Layer Detection Protocol (LLDP)
www.dell.com | support.dell.com
mode
c e s
Set LLDP to receive or transmit.
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
Defaults
Both transmit and receive
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Related
Commands
multiplier
c e s
Set the number of consecutive misses before LLDP declares the interface dead.
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
Defaults
4 x hello
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
protocol lldp (Configuration)
c e s
Enable LLDP globally on the switch.
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
tx
Enter the keyword tx to set the mode to transmit.
rx Enter the keyword rx to set the mode to receive.
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
protocol lldp (Configuration) Enable LLDP globally.
show lldp neighbors Display the LLDP neighbors
integer
Enter the number of consecutive misses before the LLDP declares the interface dead.
Range: 2 - 10
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series