Command Line Reference Guide

738 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Command
History
Usage
Information
Applies to EBGP neighbors only.
If the AS-PATH contains both public and private AS number or contains AS numbers of an EBGP
neighbor, the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software removes the private AS
numbers only if they follow the confederation numbers in the AS path.
Private AS numbers are 64512 to 65535.
neighbor route-map
c e s
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer
group.
Syntax
neighbor {ipv6-address | peer-group-name} route-map map-name {in | out}
To remove the route map, use the no neighbor {ipv6-address | peer-group-name} route-map
map-name {in | out} command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of the route
map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in the
Route map used in this command. If you identify a peer by IP address, the Route map overwrites either
the inbound or outbound policies on that peer.
Version 8.4.2.1 Introduced on C-Series and S-Series.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Version 8.4.2.1 Introduced on C-Series and S-Series.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale