Command Line Reference Guide

468 | Force10 Resilient Ring Protocol (FRRP)
www.dell.com | support.dell.com
clear frrp
c e
Clear the FRRP statistics counters.
Syntax
clear frrp [ring-id]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
Command
History
Example FTOS#clear frrp
Clear frrp statistics counter on all ring [confirm] yes
FTOS#clear frrp 4
Clear frrp statistics counter for ring 4 [confirm] yes
FTOS#
Usage
Information
Executing this command, without the optional ring-id, will clear statistics counters on all the available
rings. FTOS requires a command line confirmation before the command is executed. This commands
clears the following counters:
• hello Rx and Tx counters
• Topology change Rx and Tx counters
• The number of state change counters
Related
Commands
debug frrp
c e
Enable FRRP debugging.
Syntax
debug frrp {event | packet | detail} [ring-id] [count number]
To disable debugging, use the no debug frrp {event | packet | detail} {ring-id} [count number]
command.
Parameters
ring-id
(Optional) Enter the ring identification number.
Range: 1 to 255
Version 8.2.1.0 Introduced for the C-Series
Version 7.5.1.0 Introduced
show frrp Display the Resilient Ring Protocol configuration
event Enter the keyword event to display debug information related to ring protocol transitions.
packet Enter the keyword packet to display brief debug information related to control packets.
detail Enter the keyword detail to display detailed debug information related to the entire ring
protocol packets.