Command Line Reference Guide

ACL VLAN Group | 275
11
ACL VLAN Group
Overview
The ACL VLAN Group feature is available only on the E-Series, as indicated by this symbol under
each command heading:
e
Since VLAN ACLs exist as multiple ACLs in the CAM, the size of the ACLs can be limited in the
CAM. The ACL VLAN Group feature permits you to group VLANs and apply ACLs to the group so
that ACLs exist as a single ACL in the CAM.
Commands
The ACL VLAN Group commands are:
• acl-vlan-group
• description
• ip access-group
• member vlan
• show acl-vlan-group
• show config
• show running config acl-vlan-group
Refer to other VLAN commands in Chapter 10, Access Control Lists (ACL).
acl-vlan-group
e
Create an ACL VLAN group
Syntax
acl-vlan-group {group name}
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Note: This feature is supported on IPv4 only and can only be used with the ipv4-egacl-16k CAM Profile
with the acl-group microcode. Refer to Chapter 15, Content Addressable Memory (CAM).
group name
Specify the name of the ACL VLAN group (maximum 140 characters).
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16
characters long.
Version 6.3.1.0 Introduced on E-Series