Command Line Reference Guide

E-Series Debugging and Diagnostics | 1451
-- Line cards --
Slot Test Status Last Result Time Stamp
------------------------------------------------------
0 off none
1 off none
2 on pass Feb 16 2007 15:50:26
3 off none
4 on pass Feb 16 2007 15:50:26
5 off none
6 off none
FTOS#
dataplane-diag disable sfm-bringdown
e
Disable the automatic bringdown of the single faulty SFM identified by the SFM walk during the
RPM-SFM runtime loopback test.
Syntax
dataplane-diag disable sfm-bringdown
To re-enable the automatic SFM bringdown, use the no dataplane-diag disable sfm-bringdown
command.
Defaults
Enabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
If a full set of SFMs are online during the runtime loopback test and a failure occurs, an automatic
SFM walk is launched in an attempt to determine if the failure is due to a single faulty SFM. If
confirmed, the single faulty SFM is identified and disabled by default. This command disables the
automatic bringdown of that suspect SFM.
Related
Commands
dataplane-diag disable sfm-walk
e
Disable the automatic SFM walk that is launched after an RPM-SFM runtime loopback test failure.
Syntax
dataplane-diag disable sfm-walk
To re-enable the automatic SFM walk, use the no dataplane-diag disable sfm-walk command.
Defaults
Enabled
Command Modes
CONFIGURATION
Command
History
Version 6.5.4.0 Introduced
dataplane-diag disable loopback Disable the runtime dataplane loopback test
dataplane-diag disable sfm-walk Diable the automatic SFM walk
show diag sfm Display the loopback test results
Version 6.5.4.0 Introduced