Command Line Reference Guide

Virtual Router Redundancy Protocol (VRRP) | 1403
GigabitEthernet 3/0, IPv4 Vrrp-group: 10, VRID: 162, Version: 2, Net: 1.1.1.1
VRF: 2 orange
State: Master, Priority: 120, Master: 1.1.1.1 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 76, Gratuitous ARP sent: 1
Virtual MAC address:
00:00:5e:00:01:a2
Virtual IP address:
1.1.1.10
Authentication: (none)
Related
Commands
IPv6 VRRP Commands
The IPv6 VRRP commands are:
• clear counters vrrp ipv6
• debug vrrp ipv6
• show vrrp ipv6
• vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
• advertise-interval
• description
• disable
• hold-time
• preempt
• priority
• show config
• track
• virtual-address
clear counters vrrp ipv6
e c s
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf instance]
Parameters
Command Modes
EXEC Privilege
Command
History
virtual-address Assign up to 12 virtual IP addresses per VRRP group.
vrid
(OPTIONAL) Enter the number of an IPv6 VRRP group. Range: 1 to 255
vrf instance
(OPTIONAL) E-Series only: Enter the name of a VRF instance (32 characters maximum) to
clear the counters of all IPv6 VRRP groups in the specified VRF.
Version 8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series. Support was added for IPv6
VRRP groups in non-default VRF instances
.
Version 8.3.2.0 Introduced on E-Series TeraScale