Command Line Reference Guide

Storm Control | 1343
storm-control unknown-unicast (Configuration)
c e s
Configure the percentage of unknown-unicast traffic allowed in or out of the network.
Syntax
storm-control unknown-unicast [percentage decimal_value [in | out]] | [wred-profile name]]
[packets_per_second in]
To disable storm control for unknown-unicast traffic, use the no storm-control unknown-unicast
[percentage decimal_value [in | out] | [wred-profile name]] [packets_per_second in] command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Usage
Information
Unknown Unicast Storm-Control is valid for Layer 2 and Layer 2/Layer 3 interfaces.
percentage
decimal_value
[in | out
]
E-Series Only : Enter the percentage of broadcast traffic allowed in or out of the network.
Optionally, you can designate a decimal value percentage, for example, 55.5%.
Percentage: 0 to 100
0 % blocks all related traffic
100% allows all traffic into the interface
Decimal Range: .1 to .9
wred-profile
name
E-Series Only: (Optionally) Enter the keyword wred-profile followed by the profile
name to designate a wred-profile.
packets_per_
second in
C-Series and S-Series Only : Enter the packets per second of broadcast traffic allowed into the network.
Range: 0 to 33554431
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 E-Series Only: Added percentage decimal value option
Version 6.5.1.0 Introduced on E-Series