Command Line Reference Guide

1290 | SNMP and Syslog
www.dell.com | support.dell.com
snmp-server context
e
Define a new SNMP context.
Syntax
snmp-server context context-name
Parameters
Defaults
None
Command Modes
CONFIGURATION
Command
History
snmp-server enable traps
c e s
Enable and configure SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the no snmp-server enable traps [notification-type] [notification-option]
command.
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
Command
History
context-name
Specify the SNMP server context name.
Note: There is a 32-character limit for this parameter.
Version 8.4.1.5 Introduced on the ExaScale series.
notification-type
Enter the type of notification from the list below:
•
bgp—Notification of changes in BGP process
•
envmon—For Dell Force10 Networks, device notifications when an
environmental threshold is exceeded
• ldp—Notification of MPLS LDP traps.
• snmp—Notification of RFC 1157 traps.
•
stp —Notification of state change in Spanning Tree protocol (RFC 1493)
• vrrp—Notification of state change in a VRRP group
• xstp —Notification of state change in MSTP (802.1s), RSTP (802.1w), and PVST+
notification-option For the envmon notification-type, enter one of the following optional parameters:
•fan
• supply
• temperature
For the snmp notification-type, enter one of the following optional parameters:
• authentication
• coldstart
• linkdown
• linkup
Version 8.4.1.0 Support was added for VRRP traps.
Version 7.6.1.0 Support added for S-Series; Added support for STP and xSTP traps.