Command Line Reference Guide

1138 | Quality of Service (QoS)
www.dell.com | support.dell.com
Related
Commands
rate-shape
c e s
Shape traffic output as part of the designated policy.
Syntax
rate-shape [kbps] rate [burst-KB]
Parameters
Defaults
Burst size is 10 KB. Granularity for rate is Mbps unless the kbps option is used.
Command Modes
QOS-POLICY-OUT
Command
History
Usage
Information
rate-shape can be applied only as an aggregate policy. If it is applied as a class-based policy, then
rate-shape will not take effect.
On 40-port 10G line cards, if the traffic is shaped between 64 and 1000kbs, for some values the shaped
rate is much less than the value configured. Do not use values in this range for 10G interfaces.
Related
Commands
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
rate police Specify traffic policing on the selected interface.
qos-policy-input Create a QoS output policy.
kbps
Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On C-Series and S-Series
make the following value a multiple of 64. The default granularity is Megabits per second (Mbps).
Range: 0-10000000
rate
Enter the outgoing rate in multiples of 10 Mbps.
Range: 10 to 10000
burst-KB
(OPTIONAL) Enter a number as the burst size in KB.
Range: 0 to 10000
Default: 10
Version 8.2.1.0
Added
kbps option on C-Series, E-Series, and Series.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
rate shape Shape the traffic output of the selected interface.
qos-policy-output Create a QoS output policy.