Reference Guide

928 | Simple Network Management Protocol
www.dell.com | support.dell.com
Copy Configuration Files Using SNMP
Use SNMP from a remote client to:
• copy the running-config file to the startup-config file, or
• copy configuration files from the Dell Force10 system to a server
• copy configuration files from a server to the Dell Force10 system
All of these tasks can be performed using IPv4 or IPv6 addresses. The examples in this section use IPv4
addresses; IPv6 addresses can be substituted for the IPv4 addresses in all of the examples.
vrrp %VRRP-6-VRRP_MASTER: IPv4 vrid-1 on Vl 2 VRF default-vrf entering
MASTER.
%VRRP-6-VRRP_MASTER: IPv4 vrid-255 on Gi 3/2 VRF default-vrf
leaving MASTER
%VRRP-6-VRRP_MASTER: IPv6 vrid-150 on Po 1 VRF default-vrf enter-
ing MASTER.
%VRRP-6-VRRP_MASTER: IPv6 vrid-100 on Po 1 VRF default-vrf leav-
ing MASTER.
%VRRP-6-VRRP_BACKUP: IPv4 vrid-1 on Vl 2 VRF default-vrf entering
BACKUP.
%VRRP-6-VRRP_BACKUP: IPv6 vrid-100 on Po 1 VRF default-vrf enter-
ing BACKUP.
ecfm %ECFM-5-ECFM_XCON_ALARM: Cross connect fault detected by MEP 1 in
Domain customer1 at Level 7 VLAN 1000
%ECFM-5-ECFM_ERROR_ALARM: Error CCM Defect detected by MEP 1 in
Domain customer1 at Level 7 VLAN 1000
%ECFM-5-ECFM_MAC_STATUS_ALARM: MAC Status Defect detected by MEP
1 in Domain provider at Level 4 VLAN 3000
%ECFM-5-ECFM_REMOTE_ALARM: Remote CCM Defect detected by MEP 3 in
Domain customer1 at Level 7 VLAN 1000
%ECFM-5-ECFM_RDI_ALARM: RDI Defect detected by MEP 3 in Domain
customer1 at Level 7 VLAN 1000
<cr> SNMP Copy Config Command Completed
%RPM0-P:CP %SNMP-4-RMON_RISING_THRESHOLD: RMON rising threshold
alarm from SNMP OID <oid>
%RPM0-P:CP %SNMP-4-RMON_FALLING_THRESHOLD: RMON falling thresh-
old alarm from SNMP OID <oid>
%RPM0-P:CP %SNMP-4-RMON_HC_RISING_THRESHOLD: RMON high-capacity
rising threshold alarm from SNMP OID <oid>
Table 51-2. Dell Force10 Enterprise-specific SNMP Traps
Command Option Trap Examples