Reference Guide

894 | Service Provider Bridging
www.dell.com | support.dell.com
Enable VLAN-Stacking for a VLAN
To enable VLAN-Stacking for a VLAN:
Display the status and members of a VLAN using the
show vlan command from EXEC Privilege mode.
Members of a VLAN-Stacking-enabled VLAN are marked with an M in column Q.
FTOS#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Active U Gi 13/0-5,18
2 Inactive
3 Inactive
4 Inactive
5 Inactive
6 Active M Po1(Gi 13/14-15)
M Gi 13/13
Configure the Protocol Type Value for the Outer VLAN Tag
The Tag Protocol Identifier (TPID) field of the S-Tag is user-configurable:
Display the S-Tag TPID for a VLAN using the command show running-config from EXEC privilege
mode. FTOS displays the S-Tag TPID only if it is a non-default value.
Task Command Syntax Command Mode
Enable VLAN-Stacking for the VLAN. INTERFACE VLAN vlan-stack compatible
Task Command Syntax Command Mode
Select a value for the S-Tag TPID.
Default: 9100
CONFIGURATION vlan-stack protocol-type