Reference Guide

754 | Policy-based Routing
www.dell.com | support.dell.com
Create a Redirect List
Use the following command in CONFIGURATION mode:
The following example creates a redirect list by the name of “xyz.”
FTOS(conf)#ip redirect-list ?
WORD Redirect-list name (max 16 chars)
FTOS(conf)#ip redirect-list xyz
FTOS(conf-redirect-list)#
Create a Rule for a Redirect-list
Use the following command in CONFIGURATION REDIRECT-LIST mode to set the rules for the
redirect list. You can enter the command multiple times and create a sequence of redirect rules. Use the
seq nn redirect version of the command to organize your rules.
Command Syntax Command Mode Purpose
ip redirect-list redirect-list-name
CONFIGURATION Create a redirect list by entering the list name.
Format: 16 characters
Delete the redirect list with the
no ip redirect-list command.
Command Syntax Command Mode Purpose
seq {number} redirect {ip-address
|
sonet} {ip-protocol-number |
protocol-type [bit]} {source mask |
any | host ip-address} {destination
mask | any | host ip-address}
CONF-REDIRECT-
LIST
Configure a rule for the redirect list.
number is the number in sequence to initiate this rule
ip-address is the Forwarding router’s address
FORMAT: A.B.C.D
sonet is a sonet interface
FORMAT: sonet slot/port
ip-protocol-number or protocol-type is the type of
protocol to be redirected
FORMAT: 0-255 for IP protocol number, or enter
protocol type
source ip-address or any or host ip-address is the
Source’s IP address
FORMAT: A.B.C.D/NN, or ANY or HOST IP
address
destination ip-address or any or host ip-address is
the Destination’s IP address
FORMAT: A.B.C.D/NN, or ANY or HOST IP
address
Delete a rule with the no redirect command.
The redirect rule supports Non-contiguous bitmasks for PBR in the Destination
router IP address