Reference Guide

686 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
Use the show running-config ospf command to see the state of all the enabled OSPFv2 processes.
FTOS#show run ospf
!
router ospf 3
!
router ospf 4
router-id 4.4.4.4
network 4.4.4.0/28 area 1
!
router ospf 5
!
router ospf 6
!
router ospf 7
mib-binding
!
router ospf 8
!
router ospf 90
area 2 virtual-link 4.4.4.4
area 2 virtual-link 90.90.90.90 retransmit-interval 300
!
ipv6 router ospf 999
default-information originate always
router-id 10.10.10.10
Use the following commands in EXEC Privilege mode to get general route and links status information.
Use the following command in EXEC Privilege mode to view the OSPFv2 configuration for a neighboring
router:
Note: If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a
specific OSPF process. If you do not enter the Process ID, only the first configured process is listed.
Command Syntax Command Mode Usage
show running-config ospf
EXEC Privilege View the summary of all OSPF process IDs enables on the router.
Command Syntax Command Mode Usage
show ip route summary
EXEC Privilege View the summary information of the IP routes
show ip ospf database EXEC Privilege View the summary information for the OSPF database
Command Syntax Command Mode Usage
show ip ospf neighbor
EXEC Privilege View the configuration of OSPF neighbors.