Reference Guide

Interfaces | 413
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:00:31
FTOS#
Use the show ip interfaces brief command in the EXEC Privilege mode to view which interfaces are
enabled for Layer 3 data transmission. In the following example, GigabitEthernet interface 1/5 is in Layer
3 mode since an IP address has been assigned to it and the interface’s status is operationally up.
FTOS#show ip interface brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet 1/0 unassigned NO Manual administratively down down
GigabitEthernet 1/1 unassigned NO Manual administratively down down
GigabitEthernet 1/2 unassigned YES Manual up up
GigabitEthernet 1/3 unassigned YES Manual up up
GigabitEthernet 1/4 unassigned YES Manual up up
GigabitEthernet 1/5 10.10.10.1 YES Manual up up
GigabitEthernet 1/6 unassigned NO Manual administratively down down
GigabitEthernet 1/7 unassigned NO Manual administratively down down
GigabitEthernet 1/8 unassigned NO Manual administratively down down
Use the show interfaces configured command in the EXEC Privilege mode to view only configured
interfaces. In the example above, GigabitEthernet interface 1/5 is in Layer 3 mode since an IP address has
been assigned to it and the interface’s status is operationally up.
To determine which physical interfaces are available, use the
show running-config command in EXEC
mode. This command displays all physical interfaces available on the line cards. .
FTOS#show running
Current Configuration ...
!
interface GigabitEthernet 9/6
no ip address
shutdown
!
interface GigabitEthernet 9/7
no ip address
shutdown
!
interface GigabitEthernet 9/8
no ip address
shutdown
!
interface GigabitEthernet 9/9
no ip address
shutdown