Reference Guide

Force10 Service Agent | 357
To add a pre-defined list of actions to your policy action list:
You may add an unlimited number of three types of custom actions:
Software software show tech-support
show trace
show trace hardware
show processes communication lp—all line cards
show processes cpu
show command history
show processes ipc flow-control
show processes ipc flow-control lp—all line cards
show hardware rpm cp party-bus statistics—x2, 10s interval
show hardware rpm cp data-plane statistics—x2, 10s interval
show hardware rpm rp1 party-bus statistics—x2, 10s interval
show hardware rpm rp1 data-plane statistics—x2, 10s interval
show hardware rpm rp2 party-bus statistics—x2, 10s interval
show hardware rpm rp2 data-plane statisticsq— x2, 10s interval
show cpu-interface-stats cp—x2, 10s interval
Task Command Command Mode
Add a pre-defined list of actions to
your policy action list.
default-action [exception | hardware
| software
]
CALLHOME ACTIONLIST
Task Command Command Mode
Execute a recovery action when FTSA reaches
the test-limit. You may reload the chassis or
reset an RPM or linecard.
Note: The default test-limit is unlimited and
under this condition the recovery action will
never execute.
seq number cli-action “command” CALLHOME ACTIONLIST
Execute a show debug when FTSA discovers a
test condition. While debug is running, FTSA
will execute other pending action list items.
seq number cli-debug
“debug-command” time seconds
CALLHOME ACTIONLIST
Execute a show command when FTSA
discovers a test condition.
seq number cli-show
“show-command” repeat number
delay seconds
CALLHOME ACTIONLIST
Reset an interface when FTSA discovers a test
condition.
seq number interface-reset
interface delay seconds
CALLHOME ACTIONLIST
Table 19-3. Pre-defined Action Lists
Action List Keyword Actions Executed