Reference Guide

Force10 Service Agent | 353
Create an FTSA Policy Test List
Create the list of conditions for which FTSA should search. You may include a pre-defined list
(Table 19-1, "Pre-defined Policy Test Lists," in Force10 Service Agent) and specify additional test
conditions (Table 19-2, "Custom Policy Test Conditions," in Force10 Service Agent).
To create a new, empty policy test list:
Choose test conditions for a policy test list
Once you create a policy test list, FTOS enters the CALLHOME TESTLIST context. The list you created
is initially empty. You may choose one of three pre-defined condition lists, or create your own.
The three pre-defined condition lists are shown in Table 19-1, "Pre-defined Policy Test Lists," in Force10
Service Agent.
To add a pre-defined list of conditions to your policy test list:
Task Command Command Mode
Create a policy test list and name it. policy-test-list name CALLHOME
Table 19-1. Pre-defined Policy Test Lists
Condition Conditions Tested
Exception CPU above 85%, crash, task crash, dump, reload due to error, RPM failover due to error
Hardware
Hardware Status
SFM status transition from active to another state
RPM status transition from active to another state
Line Card transition from active to another state
Port-pipe error or transition to down
PEM transition from up to another state
AC PSU transition from up to other state
Fan Tray down or individual fan down
Environmental status
Overtemp for each item listed in show environment
Over/under-voltage for each item listed in show environment
Software SWP Timeout, IPC Timeout, IRC timeout, CPU > 85%, Memory usage > 85%
Task Command Command Mode
Add a pre-defined list of conditions to
your policy test list.
default-test [exception | hardware |
software
]
CALLHOME TESTLIST