Users Guide
– end-time: Enter the time in hours:minutes. For the hour variable, use the 24-hour format; example, 17:15 is 5:15 pm.
– offset: (OPTIONAL) Enter the number of minutes to add during the summer-time period. The range is from 1 to1440. The default
is
60 minutes.
Example of the clock summer-time recurring Command
Example of Clock Summer-Time Recurring Parameters
Dell(conf)#clock summer-time pacific recurring Mar 14 2012 00:00 Nov 7 2012 00:00
Dell(conf)#
NOTE: If you enter <CR> after entering the recurring command parameter, and you have already set a one-time daylight
saving time/date, the system uses that time and date as the recurring setting.
Dell(conf)#clock summer-time pacific recurring ?
<1-4> Week number to start
first Week number to start
last Week number to start
<cr>
Dell(conf)#clock summer-time pacific recurring
Dell(conf)#
Conguring the Oset-Threshold for NTP Audit Log
You can congure the system to send an audit log message to a syslog server if the time dierence from the NTP server is greater than a
threshold value (oset-threshold). However, time synchronization still occurs. To congure the oset-threshold, follow this procedure.
• Specify the threshold time interval before which the system generates an NTP audit log message if the system time deviates from the
NTP server.
CONFIGURATION mode
ntp offset-threshold threshold-value
The range for threshold-value is from 0 to 999.
Dell(conf)#ntp offset-threshold 9
848
System Time and Date