Users Guide

Displaying egress-queue Statistics
To display egress-queue statistics of both transmitted and dropped packets and bytes, use the following command.
• Display the number of packets and number of bytes on the egress-queue prole.
EXEC Privilege mode
show qos statistics egress-queue
Example of the show qos statistics egress-queue Command
Dell#show qos statistics egress-queue fortyGigE 0/37
Interface Fo 0/37
Unicast/Multicast Egress Queue Statistics
Queue# Q# Type TxPkts TxPkts/s TxBytes TxBytes/s DroppedPkts DroppedPkts/s DroppedBytes
DroppedBytes/s
------------------------------------------------------------------------------------------------
--------------
0 UCAST 0 0 0 0 0 0
0 0
1 UCAST 0 0 0 0 0 0
0 0
2 UCAST 0 0 0 0 0 0
0 0
3 UCAST 0 0 0 0 0 0
0 0
4 UCAST 0 0 0 0 0 0
0 0
5 UCAST 0 0 0 0 0 0
0 0
6 UCAST 0 0 0 0 0 0
0 0
7 UCAST 5575 0 624366 217 0 0
0 0
8 MCAST 0 0 0 0 0 0
0 0
9 MCAST 0 0 0 0 0 0
0 0
10 MCAST 0 0 0 0 0 0
0 0
11 MCAST 0 0 0 0 0 0
0 0
12 MCAST 0 0 0 0 0 0
0 0
Dell#
Classifying Layer 2 Trac on Layer 3 Interfaces
To process Layer 3 packets that contain Dot1p — (IEEE 802.1p) Packet classication (Layer 2 headers), congure VLAN tags on a physical
Layer 3 interface (that is congured with an IP address and is not associated with any VLAN). You can also congure a VLAN subinterface
over a physical underlying interface and classify packets using the dot1p value.
To apply an input policy map to Layer 3 physical interfaces, use the service-policy input policy-name layer 2 command in
Interface Conguration mode.
To apply a Layer 2 policy on Layer 3 interfaces, perform the following:
1 Congure an interface with an IP address or a VLAN subinterface
CONFIGURATION mode
Dell(conf)# int fo 0/0
680
Quality of Service (QoS)