Users Guide

Dell(conf)#interface vlan 30
Dell(conf-if-vl-30)#mode remote-port-mirroring
Dell(conf-if-vl-30)#tagged te 0/3
Dell(conf-if-vl-30)#exit
Dell(conf)#monitor session 1 type rpm
Dell(conf-mon-sess-1)#source remote-vlan 10 dest te 0/9
Dell(conf-mon-sess-1)#exit
Dell(conf)#monitor session 2 type rpm
Dell(conf-mon-sess-2)#source remote-vlan 20 destination te 0/10
Dell(conf-mon-sess-2)#tagged destination te 0/10
Dell(conf-mon-sess-2)#exit
Dell(conf)#monitor session 3 type rpm
Dell(conf-mon-sess-3)#source remote-vlan 30 destination te 0/11
Dell(conf-mon-sess-3)#tagged destination te 0/11
Dell(conf-mon-sess-3)#end
Dell#
Dell#show monitor session
SessID Source Destination Dir Mode Source IP Dest IP
------ ------ ----------- --- ---- --------- --------
1 remote-vlan 10 Te 0/9 N/A N/A N/A N/A
2 remote-vlan 20 Te 0/10 N/A N/A N/A N/A
3 remote-vlan 30 Te 0/11 N/A N/A N/A N/A
Dell#
Encapsulated Remote Port Monitoring
Encapsulated Remote Port Monitoring (ERPM) copies trac from source ports/port-channels or source VLANs and forwards the trac
using routable GRE-encapsulated packets to the destination IP address specied in the session.
NOTE
:
When conguring ERPM, follow these guidelines
• The Dell Networking OS supports ERPM source session only. Encapsulated packets terminate at the destination IP address or at
the analyzer.
• You can congure up to four ERPM source sessions on switch.
• Congure the system MTU to accommodate the increased size of the ERPM mirrored packet.
• The maximum number of source ports you can dene in a session is 128.
• The system encapsulates the complete ingress or egress data under GRE header, IP header, and outer MAC header and sends it
out at the next hop interface as pointed by the routing table.
• Specify flow-based enable in case of source as VLAN or where you need monitoring on a per-ow basis.
• Specify the monitor keyword in the access list rules for which you want to mirror.
• The system allows you to congure up to four ERPM sessions.
• ERPM sessions do not copy locally sourced remote VLAN trac from source trunk ports that carry RPM VLANs. ERPM sessions
do not copy locally sourced ERPM GRE-encapsulated trac from source ports.
• Flow-based mirroring is supported only for source VLAN ingress trac.
Changes to Default Behavior
• Rate-limiting is supported for the ERSPAN trac.
• You can congure the same port as both source and destination in an ERSPAN session.
• You can congure TTL and TOS values in the IP header of the ERSPAN trac.
Conguration steps for ERPM
To congure an ERPM session:
632
Port Monitoring