Users Guide

You can send iSCSI TLVs either globally or on a specied interface. The interface conguration takes priority over global conguration.
The default is Enabled.
6 (Optional) Congures the advertised priority bitmap in iSCSI application TLVs.
LLDP CONFIGURATION mode
[no] iscsi priority-bits.
The default is 4 (0x10 in the bitmap).
7 (Optional) Enter interface conguration mode to congure the auto-detection of Dell Compellent disk arrays.
CONFIGURATION mode
interface port-type slot/port
8 (Optional) Congures the auto-detection of Compellent arrays on a port.
INTERFACE mode
[no] iscsi profile-compellent.
The default is: Compellent disk arrays are not detected.
NOTE: All these congurations are available only in PMUX mode.
Displaying iSCSI Optimization Information
To display information on iSCSI optimization, use the show commands detailed in the below table:
Table 30. Displaying iSCSI Optimization Information
Command Output
show iscsi Displays the currently congured iSCSI settings.
show iscsi sessions Displays information on active iSCSI sessions on the switch that have
been established since the last reload.
show iscsi sessions detailed [session isid] Displays detailed information on active iSCSI sessions on the switch. To
display detailed information on specied iSCSi session, enter the session’s
iSCSi ID.
show run iscsi Displays all globally-congured non-default iSCSI settings in the current
Dell Networking OS session.
show iscsi Command Example
Dell# show iscsi
iSCSI is enabled
iSCSI session monitoring is enabled
iSCSI COS : dot1p is 4 no-remark
Session aging time: 10
Maximum number of connections is 256
------------------------------------------------
iSCSI Targets and TCP Ports:
------------------------------------------------
TCP Port Target IP Address
3260
860
iSCSI Optimization
437